Introduction
This guide tells you how to set the dome address you need to give your domes and address or else your DVR will not know which dome to talk to.
Tools
Parts
No parts specified.
-
-
Undo all screws on the lower dome.
-
These screws have rubber o-rings on the other side, to prevent losing these do not remove screws fully. Instead undo them slightly while pulling on dome one at a time until the dome comes off with the screws held in place with the o-rings
-
-
-
Remove these screws.
-
These screws sometimes have o-rings on them too so do not remove screws fully.
-
-
-
Using your domes install guide look up the address and protocol you would like to use and adjust these switches to match.
-
To use dennard/bbv up the coax (down the video wire) set the yellow switch to D and the blue switch to F, not all dvr's support up the coax control for bbv up the coax
-
Installation guide are linked at the start of this guide.
-
To finish screw the cover back on and attach lower dome
To finish screw the cover back on and attach lower dome